Search

Archive for June, 2006

New vacuum advance

Posted by Eman on June 30th, 2006

Installed a new vacuum advance

New fuel sending unit

Posted by Eman on June 29th, 2006

Took a test ride around the block to check out the carburetor
Seemed to run better, but still something wasn’t quite right
May have a timing issue, but not 100% sure
Replaced the fuel sending unit
Now instead of reading 1/4 tank of gas, it reads 3/4 tank!

Reinstalled the carburetor

Posted by Eman on June 28th, 2006

The carburetor came back from being inspected
Attached the carb back on the manifold

Attached the front bumper

Posted by Eman on June 27th, 2006

Swapped the left and right brackets, but still slightly crooked
Attached the splash guard
Attached the “new-to-me” chrome bumper to the brackets
Now just waiting on the front bumper guards

Rear bumper attachment

Posted by Eman on June 26th, 2006

Put all the guards and bolts through the bumper and attached them to the brackets
Adjusted the brackets the best we could, but still slightly lower on the right side
Tightened the brackets
Attached the new exhaust tip

Rear bumper bracket bolts

Posted by Eman on June 25th, 2006

Had to find and replace the bolts and lock nuts attaching the rear brackets to the frame
Moved the left bracket to the outer side of the frame and the right bracket through the middle portion of the frame
Attached the outermost bumper bolts
Removed exhaust pipe tip

Rear bumper work

Posted by Eman on June 24th, 2006

Removed rear bumper brackets

Removed carburetor again

Posted by Eman on June 12th, 2006

An out of town friend offered to rebuild the carb again… just to make sure, so I removed the carburetor for delivery

Removed old bumpers

Posted by Eman on June 11th, 2006

Loosened bumper bolts and removed front and rear bumpers

Installed seat belts & cruise-in

Posted by Eman on June 10th, 2006

Put taillight bezels back on
Fastened rear wiring harness to the rear of car
Put the front seats back in
Installed front seat belts
Reversed horn relay wires to get the horn to work
Put the instruments and dash back together
Continued to neatly arrange wires
Went to Stella’s FIRST cruise-in!
Still some hissing noise and hesitation from starting back up from a [...]