Search

Archive for the 'Electrical' Category

Trying to finalize things

Posted by Eman on May 10th, 2009

Bought another Pertronix ignition and shortened the wires to length. Bought some hex head bolts to fasten the interior door handles. We head out Friday. The forecast calls for rain. I’m starting to feel bad… but not because of the rain.

Timing

Posted by Eman on April 20th, 2009

The timing was way off (retarded) after adding the Pertronix Ignitor. But after adjustment, it’s spot-on. Hopefully that was the cause of the overheating.
Still have an exhaust leak. No idea how to fix it at this point.

Uh oh

Posted by Eman on April 18th, 2009

I’m not sure the exhaust leak is completely fixed, but it definitely doesn’t smell as bad.
Took a trip around the neighborhood. Stalled once and hiccupped once. Went to fill her up with gas. Made it home fine.
Checked the transmission fluid which was non-existent. Filled it up to the proper level, then noticed something…
Radiator was overflowing. [...]

Exhaust Manifold Back On

Posted by Eman on April 17th, 2009

Put the exhaust manifold back on
Slid in the manifold gaskets (coated with blue gasket maker)
Tightened everything up
Installed the generator

Pertronix Ignitor

Posted by Eman on April 16th, 2009

Got the electronic ignition in the Studebaker all squared away. Unfortunately tonight was supposed to be an exhaust manifold install.

Tiny update

Posted by Eman on April 13th, 2009

Removed the points and condenser in preparation for the new electronic ignition.

Radio power

Posted by Eman on January 28th, 2009

Put a ring connector on the bare radio wire
Plugged in a cheap antenna from Autozone
Turned the knob
Voila! The radio works and lights up
Also did a little shop cleanup today

She started… Again!

Posted by Eman on June 21st, 2007

Installed the passenger side vent door
Attached the hoses to the radiator
Installed the radiator
Added 50/50 antifreeze
Reattached all of the wiring
Attached the fan belt and adjusted with the generator and bracket
Squirted the valve stems with oil
Started the car
Checked the valves for oiling
Installed the valve covers, grommets, gaskets, nuts
Adjusted the timing with a timing light
Shortened the accelerator linkage
Slightly [...]

Generator install

Posted by Eman on June 17th, 2007

Turned one of the pipes on the water pump housing to be perpendicular to the housing
Painted the area around it (touch-up work)
Painted the generator low gloss black
Installed the generator… Just need to figure out where the hoses go around it
Removed the fender vent doors and the old gaskets around them

Trying to start her up

Posted by Eman on May 29th, 2007

Timed the distributor
Tried to start her up, but the battery was weak and all she did was grumble
Removed the exhaust valve gaskets due to smoke from the driver’s side